How nylon tube machining performed ? Many friends often use nylon tube nylon tube has a good feel characteristics , they will also curious how good nylon tube machining how to proceed? Now we come to dwell with you next machined nylon tube is how to do .
　　
　　( 1 ) When turning machining , lathe speed is not too fast, generally require at 200 rev / min , feed rate should not be too large, otherwise the resulting heat expansion products , processed completely out of line size.
　　
　　( 2 ) before turning the corner should be bigger than the turning of steel , after turning rake angle larger than the former angle 15 º -25 º, the angle of 15 º C or so, just in general oil steel knives can be, without the use of alloy tool.
　　
　　( 3 ) planer processing, should not use knife in hand , but the use of a knife to processing, the angle is smaller planers , hand knife will cause chipping off pieces of smooth nylon parts .
　　
　　( 4 ) should be used when turning the oil , not suitable for water-based emulsion as nylon absorbent.
　　
　　( 5 ) at the time of drilling , lathe can not exceed 200 r / min, 20mm drill hole if it should be a small drill bit , slowly and gradually expand to prevent cracking , when the hole in the top to draw oil fossa , should be re- zoned nest drilling , drilling plans after the first nest if the workpiece is easy to float along with the drill bit , and easy bruising processing personnel , appears waste.